|Garage Floor Coatings|
Excel-Coat Epoxy Coatings Data Sheet
Excel-Coat Garage Floor Coating System is comprised of a two-component, high solids epoxy mastic with a clear or tinted two-component polyester urethane topcoat.
Excel-Coat Garage floor coating is specifically designed for light to medium vehicular traffic areas in residential homes and warehouse applications.
The Excel-Coat Garage floor coating is comprised of three, two- component products for a total system application.
The Excel-Coat PC-155 comes in 2-gallon kits, CM-15 comes in 1-gallon kits and CT-332 comes in 1 1/2-gallon kits.
Twelve months from shipping date stored below 80°. Do not allow product to freeze.
Excel-Coat CM-15 comes in Sandstone and Gray. CT-332 is clear. CM-15 and CT-352 are available in other colors upon request.
Before any work is started, the applicator shall thoroughly examine all surfaces for any deficiencies. Should any deficiencies exist, the Architect, Owner or General Contractor shall be notified in writing and any corrections necessary shall be made.
Cold or inclement weather will affect the cure time of all Excel-Coat products. Do not install over wet substrate, in the rain or if the threat of rain exists within 24 hours.
Refer to Epoxy Garage Floor Coatings Application Guide for detailed instructions of the installation methods.
STORAGE AND HANDLING:
Store Excel-Coat products in a cool dry area and protect from freezing. It will be necessary to stir Excel-Coat materials before using. Clean mixing and application tools with the appropriate solvent-based cleaners. Dispose of empty containers properly according to current Local, State and Federal regulations.
HEALTH AND HAZARD INFORMATION:
Use the product with adequate ventilation; appropriate breathing apparatus (ventilators) and personal protection. Users must read container label and Material Safety Data Sheet (MSDS) for specific health and safety precautions prior to use.
Slip Resistance Disclaimer: Excellent Coatings International recommends the use of slip-resistant aggregate in all floor coating systems that may have exposure to wet or oily conditions. However, even textured surfaces can be slippery under certain conditions. The type of activity, maintenance procedures, and type of footwear may all be factors relative to the amount of slip resistance that is needed. Excellent Coatings International will not assume responsibility for determining the type or amount of slip resistance that is required for any given project.
AVAILABILITY AND COST:
Immediately available from Excellent Coatings International and authorized distributors. Cost data is available from your local Excellent Coatings International authorized representative. For the name and number of the nearest local representative, call Excellent Coatings International at (800) 473-3817.
Cleaning can be accomplished by scrubbing with normal detergent soap and water. Organic Citrus cleaners may be used on the Excel-Coat systems. Follow cleaning product directions.
GUARANTEE / WARRANTY:
Excellent Coatings International warrants Excel-Coat materials to be free of defects and manufactured to meet published physical properties for a period of one year following the date of shipment, provided that the product has been applied according to the manufacturer's instructions. Under this warranty, Excellent Coatings International will provide, at no charge, product in containers to replace any product proved to be defective in applications recommended by us as suitable for this product. All claims concerning the products' defects must be made within twelve months of shipment and within thirty days of discovery. Absence of such claims in writing during this period will constitute a waiver of all claims with respect to such product. This warranty is IN LIEU OF any and all other warranties, expressed or implied, including, but not limited to, any implied warranty of MERCHANTABILITY of fitness for a specific purpose.
Authorized local representatives are available to provide design assistance and on-site instruction for our products. Excellent Coatings International provides assistance in design and development of special applications and partial inspection. Part-time or full-time inspection and instruction are available on a fee basis upon arrangement. Technical data is available upon request.